| Author |
Message |
|
Bbviper
|
 Posted: Sat Sep 03, 2005 10:45 am |
|
Joined: Wed Aug 13, 2003 5:03 pm
Posts: 315
Location: Bonduel , WI
|
|
I tried the other day to seperate the old pulley from timing gear behind it.
They are like bound together.
Any hints on how to pull them apart without trashing the timing gear on the crank so I can put my 3SX pulley on?
Tim
_________________
Is it true that cannibals won't eat clowns because they taste funny?
What happens if you get scared half to death twice?
|
|
| Top |
|
 |
|
G-ELL
|
Posted: Sat Sep 03, 2005 5:01 pm |
|
Joined: Wed Aug 13, 2003 1:18 am
Posts: 3153
Location: Lehigh Valley, PA
|
|
Yeh, it can be a fight sometimes to get it off.
What I do is grab the sides of the pulley with each hand and wiggle it back and forth till it comes off. If that doesn't work, squirt some PB blaster on the alignment dowel and wait a little bit.
With the crank pulley bolt and washer out of the way, you should see that dowel inside the hole.
_________________ 06 Blue EVO 9
|
|
| Top |
|
|
